Labor Demand Templates are the staffing requirements to produce a particular product. This article will walk through the steps of copying an existing labor demand template using the Demand Planning Tool.
1. On the Indeavor Home Page, select the Demand Planning icon
- Make sure you're accessing data in the correct OU by checking the OU selected on the top-right corner of the webpage
2. Select the Labor Demand Template icon located on the left-hand side of the page
3. Locate the row of the Labor Demand Template that needs to be copied, in the Actions column on the far right-hand side of the table select the Copy icon 
to copy the Labor Demand Template
4. If necessary, update the following before selecting the Continue to Dimensions → button:
- Template Name of the Labor Demand Template
Note: The name of the copied Labor Demand Template is Copy of <Old Labor Demand Template
Name>. This will likely need to be updated. - Short Name of the Labor Demand Template
- If needed, the Demand Category that the Labor Demand Template is tied to
- If needed, the Location on which the Labor Demand Template can be enabled
5. If necessary, to add a new dimension to the Labor Demand Template, do the following before selecting the Add this Dimension button:
- Use the drop-down menus to select the Job, Shift, Demand Category, and Location for the dimension being created
- Select the appropriate Start Offset and End Offset for the dimension if they are a time offset from the start and end times that the Labor Demand Template will be applied for
- Select the staffing level required by adjusting the Employee Count
Note: If the Employee Count values are all the same, just fill out the minimum value
and the others will be set to the minimum value. The minimum value can never be greater
than the optimum value and the optimum value can never be greater than the maximum value.
- Repeat the steps above to add additional dimensions until all the needed dimensions are added to the Labor Demand Template
6. If necessary, to modify an existing dimension, navigate to the Dimensions Created table at the bottom of the page and select the Edit Pencil icon 
in the Actions Column to modify the following before selecting the Update this Dimension button:
- Job, Shift, Demand Category, and Location of the dimension/demand
- Start Offset and End Offset for the demand/dimension
- Employee Count of the demand/dimension
7. If necessary, to remove an existing dimension, navigate to the Dimensions Created table at the bottom of the page and select the Delete Trash Can icon 
in the Actions Column
8. After making the necessary modifications to the dimension(s), select the Review Template → button
9. If the modifications look correct, select the Save Template button to save the modifications made to the Labor Demand Template